ClearOne V-There 2100 Uživatelská příručka stáhnout pdf (Strana 32)

4 - 4

Terminal ID Table

Data Format Editor Commands

When working with the Data Format Editor, a virtual cursor is moved along your

input data string. The following commands are used to both move this cursor to

different positions, and to select, replace, and insert data into the final output.

For examples that use the Data Format Editor commands, refer to Data

Formatter on page 4-15.

Send Commands

Send all characters

F1 Include in the output message all of the characters from the input

message, starting from current cursor position, followed by an insert

character. Syntax = F1xx where xx stands for the insert character’s hex

value for its ASCII code. Refer to the ASCII Conversion Chart (Code

Page 1252), beginning on page A-4 for decimal, hex and character

codes.

Send a number of characters

F2 Include in the output message a number of characters followed by an

insert character. Start from the current cursor position and continue for

“nn” characters or through the last character in the input message,

followed by character “xx.” Syntax = F2nnxx where nn stands for the

numeric value (00-99) for the number of characters, and xx stands for

the insert character’s hex value for its ASCII code. Refer to the ASCII

Conversion Chart (Code Page 1252), beginning on page A-4 for

decimal, hex and character codes.

F2 Example: Send a number of characters

Send the first 10 characters from the bar code above, followed by a

carriage return. Command string: F2100D

F2 is the “Send a number of characters” command

10 is the number of characters to send

0D is the hex value for a CR

The data is output as: 1234567890

F2 and F1 Example: Split characters into 2 lines

Terminal Model(s) Terminal ID

Serial RS232

000

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 151 152

Žádné komentáře

ClearOne V-There 2100 Uživatelská příručka Strana 32